Remote Gain Knob for all Toro Tech Audio Rage Mono and Rage Micro Mono Block Amplifiers. This remote will allow you to lower the signal of the amplifiers gain. This is useful when lowing the subwoofer volume quickly is needed. 

• 17 Foot Cable 
• Gain knob to control bass 
• Mounting brackets

This is a Universal RCA adapter is used to activate the Auto Turn On Via RCA feature in all TORO Amplifiers.

Each set has two male RCA plugs with short high grade braided cables that are pre-stripped to form bare (+) & (-) connections. These bare wires then can be attached to any O.E.M. speaker outputs from a factory radio and plugged into any of the amps listed above.

They will take any factory speaker outputs up to 10V and can be inserted into the amps RCA inputs. This will activate the ATO feature by sensing the radios DC Off Set eliminating the need for a 12V turn on lead. The 12V turn on lead is converted into a switched 12V out to turn on any additional products. 

FEATURES:

• Connects to bare speaker wires and converts to RCA high-level signal
• Each pack has two sets of male RCA plugs and four dummy resistors
• Dummy resistors are for newer cars that need a fake signal to power on
• Designed to activate the auto turn on feature
• Eliminates the need for a 12V turn-on lead
• RCAs made with braided cable

This MOLEX 4 Pin speaker input plug connects to the TORO Micro Rage MR2 - Mono Block and the MRX2 - 2 Channel Micro Amplifiers. 

Both positives inputs are internally wired together. The same applies for both negative leads. This allows you to connect both positives together or allows you to connect 2 different speakers positives or negatives. 

This MOLEX 8 Pin speaker input plug connects to the TORO Micro Rage MRX4 - 4 Channel Micro Amplifiers. 

Both sets of positives inputs are internally wired together. The same applies for both sets of negative leads. This allows you to connect both sets of positives together or allows you to connect 2 different speakers positives or negatives.